:::
Browsing this Thread:
1 Anonymous Users
|
Re: Target not in debug mode 的問題
|
||||
|---|---|---|---|---|
|
初級會員
 
|
根據Error Message看來
1.使用ICD2模擬，請把低電壓燒錄關掉 2.使用ICD2模擬，請把WDT關掉 3.請注意你板子上的震盪頻率，並選擇正確的震盪頻率選項 應該這樣 就可以了
發表於: 2005/3/30 11:49
|
|||
|
||||
|
Target not in debug mode 的問題
|
||||
|---|---|---|---|---|
|
新會員
|
各位前輩,我在進行ICD 2燒錄時,不論是使用MPASM或C18,都一直顯示下面的句子,可否告訴晚輩是哪裡的問題阿,謝謝大家!
MPLAB ICD 2 Ready ............. ICDWarn0013: Low Voltage Programming cannot be enabled when ICD 2 is used as a debugger. Disable Low Voltage Programming? ICDWarn0014: Watchdog Timer cannot be enabled when ICD 2 is enabled as a debugger. Disable Watchdog Timer? .............. ICD0083: Target not in debug mode, unable to perform operation
發表於: 2005/3/30 2:11
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
