Browsing this Thread:
1 Anonymous Users
|
使用MCP6024發覺Offset電壓居然比MCP6284來得大,Why?
|
|
資深會員
Joined
: 2006/4/17 11:12 最後登入時間
: 1/15 15:19
Group:
註冊會員
Level : 23 HP : 0 / 562 MP : 222 / 29752 EXP : 50
|
版主您好: 我原本使用MCP6284做一個減法器的應用,這顆OP的Offset=3mv(max),後來我又申請了一顆MCP6024,Offset=0.5mv(max),輸出端是用PIC的A/D以10bit的解析度讀取,經由連續取樣觀察其平均值時,發覺在輸入端電壓都為0時,由A/D端讀到的值居然是後者比前者還大,各三顆比較結果都一樣,請問為什麼Offset標示比較低的OP實際運作的卻不符應有的預期結果?我使用的電源電壓為5V,不過我發現Microchip的OP平均的Offset和其他廠牌比起來確實比較低,以上疑問PO上來,謝謝指導。
發表於: 2006/12/15 10:48
|
|
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.