:::
Browsing this Thread:
1 Anonymous Users
|
Re: Program Memory 不是 flash type 記憶體嗎?
|
||||
|---|---|---|---|---|
|
新會員
 
|
Thanks a lot. I found the problem myself, too. Actually, when I turn off the LAB-X1 board, just the program stop running. But it is definitely true that the program still resides in the PIC18F452.
And your opinion is valuable to me, too. Now my motor is running like hell and next step would be discover its RPM through the CAPTURE mode. Jack
發表於: 2005/6/18 4:20
|
|||
|
||||
|
Re: Program Memory 不是 flash type 記憶體嗎?
|
||||
|---|---|---|---|---|
|
管理員
|
你應該是使用 MPLAB ICD2 來 Program 的吧 ? 若是的話那一定是了啦 ! 因為你沒說是那一個 IC. 若是搭配 MPLAb ICD2 , 以下幾點就要注意了 : 1. 在 MPLAB IDE 功能表中 , MPLAB ICD2 要被選為 Programmer 而不是 Debugger . 否則 MCU 在 Program 完成後要靠 MPLAB IDE 下 Command 才能動做. 2. Configuration Bits 要設對 , 尤其是震盪模式 ! 否則 IC 也動不了 ! 最後 , 祝你幸運地完成你的程式 :) 
發表於: 2005/6/14 22:19
|
|||
|
||||
|
Program Memory 不是 flash type 記憶體嗎?
|
||||
|---|---|---|---|---|
|
新會員
|
各位先進：
Program Memory 不是 flash type 記憶體嗎? 那為何我program 晶片後？ 關掉電源後再開啟，程式似乎不存在了呢？ Thanks in advance.
發表於: 2005/6/14 6:24
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
