Re: 請問燒錄出現以下訊息,會是什麼原因造成的?
|
||||
---|---|---|---|---|
資深會員
![]() ![]() ![]() |
您可以參考一下Microchip Knowledge Base的相關問題說明.
https://microchipsupport.force.com/s/a ... e-program-speed-to-Normal
發表於: 2022/3/11 13:14
|
|||
不要盲目地從一堆“嘗試”中去找答案;將時間用來找尋“最正確”的方法。
|
||||
|
Re: 請問燒錄出現以下訊息,會是什麼原因造成的?
|
||||
---|---|---|---|---|
中級會員
![]() ![]() ![]() |
了解,之後找時間會再測試,感謝您的回覆。
發表於: 2022/3/10 10:58
|
|||
|
Re: 請問燒錄出現以下訊息,會是什麼原因造成的?
|
||||
---|---|---|---|---|
管理員
![]() ![]() ![]() |
HengChieh你好,可能是重新焊接後改變了線路阻抗而改善了訊號的品質,
可以嘗試重新焊接原先不能燒錄的MCU或改變燒錄線路的連接方式後再次測試。
發表於: 2022/3/9 18:36
|
|||
|
Re: 請問燒錄出現以下訊息,會是什麼原因造成的?
|
||||
---|---|---|---|---|
管理員
![]() ![]() ![]() |
HengChieh你好,有可能為燒錄電路上的電容、電感、其他元件或電路設計導致這個問題。
可以嘗試以下幾種方式來測試是否能改善: • 確認燒錄線路連接正確。 • 移除燒錄電路上的部分元件。 • 更換連接的USB線和USB孔,如果有使用HUB請先暫時不要使用。 • 使用外部供電而不要使用燒錄器的內部電源供電。 • 使用另一組燒錄工具。
發表於: 2022/3/8 14:15
|
|||
|
請問燒錄出現以下訊息,會是什麼原因造成的?
|
||||
---|---|---|---|---|
中級會員
![]() ![]() ![]() |
請問出現以下錯誤訊息,大概是什麼原因造成的,有試著降速,但情況依舊。
MCU型號:ATSAMD51J18A Erasing... The following memory area(s) will be programmed: program memory: start address = 0x0, end address = 0x17ff program memory: start address = 0x9e00, end address = 0x9fff configuration memory Verify failed. [ Pgm ] at 0x0, expected 0x2001fff8, got 0xffffffff You have set the program speed to Normal. The circuit on your board may require you to slow the speed down. Please change the setting in the tool properties to low and try the operation again. Programming did not complete.
發表於: 2022/3/7 13:27
|
|||
|