Browsing this Thread:
1 Anonymous Users
|
18F13K50 使用MCC燒錄後沒反應
|
|
初級會員
Joined
: 2014/10/12 10:59 最後登入時間
: 2021/12/21 14:06
Group:
註冊會員
Level : 3 HP : 0 / 73 MP : 9 / 2048 EXP : 93
|
目前使用 MPLAB X IDE V5.35 MCC 3.95
目前使用MCC先設定System Module Oscillator Select 設定為 內部震盪(Internal RC Oscilaltor) System Clock Select 為 FOSC Internal Clock 為1Mhz_HF
I/O腳將RB5 設定為輸出,一開始就輸出High
之後將這個設定Generate到剛建好的專案裡面 然後發現他的I/O都沒反應
本來想要用Debug去看他有沒有在跑,但是找了一下才發現要另外買Debug Header,所以沒辦法使用debug去看他。
第一次使用MCC但是不曉得是不是設置這些就可以跑了,反覆將Internal Clock設置不同的Mhz也都是一樣。
發表於: 2020/6/3 14:19
|
|
|
Re: 18F13K50 使用MCC燒錄後沒反應
|
|
初級會員
Joined
: 2014/10/12 10:59 最後登入時間
: 2021/12/21 14:06
Group:
註冊會員
Level : 3 HP : 0 / 73 MP : 9 / 2048 EXP : 93
|
目前測試的時候發現目前是使用Pickit3供電,燒錄完之後要拔掉再接上去,他才會動作。
但是有一個滿奇特的點是,我目前只對IC設定I/O腳為輸出,把Pin ModePin Mode i/o的START HIGH做勾選再燒錄,示示波器量到的波形是60HZ的訊號。
當我把Pin ModePin Mode i/o的START HIGH取消勾選再燒錄就變成Low
想問一下為什麼會出現這個狀況呢?
發表於: 2020/6/4 10:31
|
|
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.