:::
Browsing this Thread:
1 Anonymous Users
|
Re: 請問一下...
|
||||
|---|---|---|---|---|
|
初級會員
 
|
看起來
好像是 你的燒錄設定 震盪模式 要改一下 可以請你POST你實體IC的震盪器頻率(是RC還是OSCILLATOR) 以及你的燒錄設定 OSC的選項嗎???
發表於: 2004/12/1 1:24
|
|||
|
||||
|
請問一下...
|
||||
|---|---|---|---|---|
|
中級會員
|
大家好 我有一個 小問題想請教大家
我在使用MPLAB模擬時 在Program 這一歩 出來結果OUTPUT都是顯示如下 Connecting to MPLAB ICD 2 ...Connected Setting Vdd source to target Target Device PIC16F873A found, revision = b4 ...Reading ICD Product ID Running ICD Self Test ...Passed MPLAB ICD 2 Ready Programming Target... ...Erasing Part ...Programming Program Memory (0x0 - 0xEFF) ...Loading DebugExecutive ...Programming DebugExecutive ...Programming Debug Vector Verifying... ...Program Memory ...Debug Executive ...Debug Vector ...Verify Succeeded Programming Configuration Bits .. Config Memory Verifying configuration memory... ...Verify Succeeded Connecting to debug executive ICD0083: Target not in debug mode, unable to perform operation MPLAB ICD 2 Ready 它卻出現Target not in debug mode, unable to perform operation 我一值找不出原因 請各位幫忙 我使用的模擬器是ICD 2 PIC為16F873A 謝謝大家 
發表於: 2004/11/29 14:27
|
|||
|
||||
You can view topic.
你 不可以 發起新主題
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
