DSPIC30F2012-20I/SP
|
||||
---|---|---|---|---|
新會員
|
發表於: 2008/10/16 11:33
|
|||
|
Re: Anyone use Graphics PICtail Plus Board?
|
||||
---|---|---|---|---|
新會員
|
DId you use the HEX file provided by Microchip? I did this way, but what I got was a blank screen.
發表於: 2008/1/23 10:06
|
|||
|
Re: Lookng for the chip
|
||||
---|---|---|---|---|
新會員
|
I know, so far no one reply my inquiry. I like to try to order other than microchip DIRECT.
發表於: 2007/8/9 11:46
|
|||
|
Lookng for the chip
|
||||
---|---|---|---|---|
新會員
|
Can anyone tell me where I can buy dsPIC30F6014A based microprocessor evaluation board?
I also need 100 pieces of PIC18F4523-I/P chip. Any information is appreciated. fan1217@yahoo.com
發表於: 2007/8/9 9:59
|
|||
|
ICD dead?
|
||||
---|---|---|---|---|
新會員
|
I have 3 ICD2, and recently the one which purchased 5 years ago is not responding to USB port. The rest 2 ICD2 are working perfectly with exact setting & hardware. Does anyone know the causes of first ICD2?
Thanks in advance.
發表於: 2007/3/15 17:35
|
|||
|
Re: TIMER0 Problem
|
||||
---|---|---|---|---|
新會員
|
Thanks for replying. But the issue is it works with previous MPLAB IDE not MPLAB V6.6. That means I have to modiy all of my programs to complite with MPLAB V6.6. I guess that is not the way should be.
發表於: 2004/8/12 17:27
|
|||
|
Re: 無法用icd2的除錯模式...
|
||||
---|---|---|---|---|
新會員
|
I 100% agree with you. Oscillator has no problem at all.
I tested a program with MPLAB v6.3 without any error, when I tested MPLAB V6.6 with same program, ERROR keep on and on.
發表於: 2004/8/12 17:17
|
|||
|
TIMER0 Problem
|
||||
---|---|---|---|---|
新會員
|
I wonder why. The program I wrote to create 100ms delay was working properly with ICD2 plugged in. Recently, I installed MPLAB v6.6, and same program is not working anymore with ICD2 plugged in. Thanks for any comments.
MCU: PIC18F8680 DELAY_100MS ................movlw 0xFD ................movwf TMR0H ................movlw 0xA0 ................movwf TMR0L ................movlw 0x85 ................movwf T0CON ................bcf INTCON,TMR0IF ................btfss INTCON,TMR0IF ................goto $-2 ................movlw 0x00 ................movwf T0CON ................return
發表於: 2004/8/10 15:22
|
|||
|
Re: ICD2 ERROR LED
|
||||
---|---|---|---|---|
新會員
|
However, MPLAB IDE does not show anything at all.
發表於: 2004/7/2 10:15
|
|||
|